Draw It Wrong
the mask is drawn wrong on purpose, so the chip comes out right.
a story in four chapters on optical proximity correction: spray paint through a stencil held off the wall and its corners come out round; light through a chip's mask does the same, so the mask is drawn wrong on purpose, with serifs and hammerheads, and today a computer draws masks that look little like the chip they print
Optical proximity correction. Chip lines are now smaller than the light that prints them: ArF immersion light is 193 nm, and its lines are a few tens of nanometres. The lens blurs the mask by its spot, so the light that reaches the resist is the mask smoothed out, and the resist prints wherever that light passes its threshold. Near an inner corner light arrives from both arms and pools, so the corner fills in; near an outer corner there is less glass around and the light starves, so it prints round; a line end starves on three sides and prints short. In the card's model the inner corner gets about 1.5 times the light of a straight edge, the outer corner about half, and a line end about three quarters; the chips on the print are those computed values. A stencil that stands off the wall blurs the same way, because paint mist drifts under its edges, and the card draws it with the same model. The fix is to draw the mask wrong on purpose: a serif (a small square) on an outer corner, a notch in an inner one, a hammerhead on each line end. Serifs, hammerheads and mousebites (the notch) are among the correction features Fritze et al. draw, with scattering bars, in "Subwavelength Optical Lithography with Phase-Shift Photomasks" (MIT Lincoln Laboratory Journal 14(2), 2003); they date chip features dropping below the wavelength to the mid-1990s. The last chapter hands the job to a solver: it treats the mask as the unknown, prints it through the same model, compares with the design and moves every pixel of the mask a little toward a better print, again and again. That is inverse lithography (ILT) in small: it grows serifs, notches and hammerheads by itself, and its print matches the design to under 1% of the area in this model, against about 10% for the mask as drawn. Its mask is still an L with bumps; the masks for a modern chip, far below the wavelength, bear little resemblance to the pattern they print (the same paper). They are computed by software that models the print and corrects the mask, and by NVIDIA's own estimate at the launch of cuLitho (2023) computational lithography takes tens of billions of CPU hours a year: a vendor's figure, said as theirs. The model is a toy: an incoherent Gaussian blur with sigma = 0.21 lambda / NA (the Gaussian approximation to an Airy spot, Zhang, Zerubia and Olivo-Marin, Applied Optics 2007) for 193 nm at NA 1.35, so sigma is 30 nm, and a resist that is a threshold set so a long 70 nm line prints at 70 nm. Real OPC models partially coherent imaging, the mask's thickness and the resist, calibrated on printed wafers. The photons are drawn as characters, cyan as a false colour since 193 nm is invisible, and one stands for very many; where each lands is the model sampled (a point in an opening, then the blur's spread). The zoom out to a whole chip is a drawn pattern, seeded, not a real layout and not to scale.
Concepts: optics, optimization, light.
An idea you find out by playing, on Wundr, made by @neelu.
On the shelf shape, and also on senses.
More on shape
- Align: hang them straight. trust the bubble.
- Arrow: push the wrench sideways, and the bolt moves up or down.
- Coast: how long is this coast?
- Crease: a seam vanishes when the pattern crosses it.
- Dry: paint over the red. the brush holds only so much ink.
- Epicycle: every drawing is secretly spinning circles.